Default I2C Addresses & Voltage Notes
Handy bench table when chaining several sensors onto a single SDA / SCL bus. Remember that most breakout boards already carry 4.7 kΩ or 10 kΩ pull-up resistors — if you put five or six modules on one bus, parallel pull-ups can drop below 1 kΩ and distort rising edges.
| Module |
Default I2C Hex |
Alt Address |
Board Supply |
Logic Safe on 5V Uno? |
| BH1750FVI (GY-302) | 0x23 | 0x5C (ADDR=HIGH) | 3.3V – 5V | Yes (10k pull-ups to 3.3V LDO) |
| VL53L0X / VL53L1X | 0x29 | Programmable via XSHUT | 3.3V – 5V | Yes (onboard levelfet) |
| INA226 Current | 0x40 | 0x41..0x4F (A0/A1) | 2.7V – 5.5V | Yes (native 5V logic) |
| SHT31-D | 0x44 | 0x45 (ADR=VIN) | 2.4V – 5.5V | Yes (native wide VDD) |
| ADS1115 16-bit ADC | 0x48 | 0x49, 0x4A, 0x4B | 2.0V – 5.5V | Yes (power VDD from 5V on Uno) |
| MPU-6050 / ICM-42688 | 0x68 | 0x69 (AD0=HIGH) | 3.3V – 5V | Use 3.3V or BSS138 on bare SPI |
| BME280 (6-pin purple) | 0x76 | 0x77 (SDO=VCC) | 3.3V – 5V | Check silkscreen: 4-pin = 3.3V only |
Hardware I2C Pins by Board
| Board | SDA | SCL | Logic Voltage |
| Arduino Uno R3 / Nano (ATmega328P) | A4 | A5 | 5.0V |
| Arduino Leonardo / Pro Micro (32U4) | D2 | D3 | 5.0V / 3.3V |
| ESP32 DevKit (WROOM-32) | GPIO 21 | GPIO 22 | 3.3V only |
| ESP32-S3 DevKitC | GPIO 8 (or Wire.begin(sda, scl)) | GPIO 9 | 3.3V only |
| Raspberry Pi Pico (RP2040, Wire0) | GP4 | GP5 | 3.3V only |
15-Line I2C Bus Scanner Sketch
#include <Wire.h>
void setup() {
Wire.begin();
Serial.begin(115200);
while (!Serial) {}
Serial.println("Scanning I2C 0x08..0x77:");
for (uint8_t addr = 8; addr < 120; addr++) {
Wire.beginTransmission(addr);
if (Wire.endTransmission() == 0) {
Serial.print("Found device at 0x");
if (addr < 16) Serial.print("0");
Serial.println(addr, HEX);
}
}
}
void loop() {}